Profiles

Jörgen

Jörgen Gladh

Postdoktor

View page in English
Arbetar vid Fysikum
Telefon 08-553 786 87
E-post gladh@fysik.su.se
Besöksadress Roslagstullsbacken 21
Rum T6:1001
Postadress Fysikum 106 91 Stockholm

Om mig

Jag arbetar i Anders Nilssons forskargrupp, XSoLaS som postdoktor/forskningsassistent och började i november 2017. Jag har en civilingenjörsexamen i teknisk fysik från Karlstads universitet och jag gjorde min doktor i kemisk fysik här vid Stockholms universitet. Jag jobbar nu med konstruktionen av en ny experimentell kammare för att driva kemiska reaktioner med hjälp av THz-strålning, och senare göra mätningar på de kemiska reaktionerna med röntgenspektroskopier.

Publikationer

I urval från Stockholms universitets publikationsdatabas
  • Henrik Öberg (et al.).
  • 2017. Jörgen Gladh, Henrik Öström, Nils Mårtensson.

    This thesis presents experimental studies of three different chemical reaction steps relevant for heterogeneous catalysis: dissociation, desorption, and oxidation. CO on single-crystal metal surfaces was chosen as the model systems.

    X-ray absorption spectroscopy (XAS) and x-ray emission spectroscopy (XES) provide information about the electronic structure, and were performed on CO/Fe to measure both a non-dissociative, and a pre-dissociative state. The measurement on the pre-dissociative state showed a π →  π* excitation, which implies a partly broken internal π bond in the molecule.

    Ultrafast laser-induced reactions were used to examine the dynamic properties of desorption and oxidation. Here CO/Ru and CO/O/Ru were used as model systems. Desorption of CO from a Ru surface involve both hot electrons and phonons. In the case of CO oxidation from CO/O/Ru a pronounced wavelength dependence of the branching ratio between desorption and oxidation was observed. Excitation with 400 nm showed a factor of 3-4 higher selectivity towards oxidation than 800 nm. This was attributed to coupling to transiently excited, non-thermalized electrons.

    Finally, by performing optical pump/x-ray probe XAS and XES changes in the electronic structure during the reaction could be followed, both for desorption and oxidation. In the CO/Ru experiment, two different transient excitation paths were observed, one leading to a precursor state, and one where CO moves into a more highly coordinated site. Using selective excitation in XES, these were shown to coexist on the surface. In the oxidation experiment, probing the reacting species located near the transition state region in an associative catalytic surface reaction was demonstrated for the very first time.

  • 2015. Henrik Öberg (et al.). Surface Science 640, 80-88

    We present density functional theory modeling of time-resolved optical pump/X-ray spectroscopic probe data of CO desorption from Ru(0001). The BEEF van der Waals functional predicts a weakly bound state as a precursor to desorption. The optical pump leads to a near-instantaneous (<100 fs) increase of the electronic temperature to nearly 7000 K. The temperature evolution and energy transfer between electrons, substrate phonons and adsorbate is described by the two-temperature model and found to equilibrate on a timescale of a few picoseconds to an elevated local temperature of similar to 2000K. Estimating the free energy based on the computed potential of mean force along the desorption path, we find an entropic barrier to desorption (and by time-reversal also to adsorption). This entropic barrier separates the chemisorbed and precursor states, and becomes significant at the elevated temperature of the experiment (similar to 1.4 eV at 2000 K). Experimental pump-probe X-ray absorption/X-ray emission spectroscopy indicates population of a precursor state to desorption upon laser-excitation of the system (Dell'Angela et al., 2013). Computing spectra along the desorption path confirms the picture of a weakly bound transient state arising from ultrafast heating of the metal substrate.

  • 2013. T. Katayama (et al.). Journal of Electron Spectroscopy and Related Phenomena 187, 9-14

    We report on an experimental system designed to probe chemical reactions on solid surfaces on a sub-picosecond timescale using soft X-ray emission spectroscopy at the Linac Coherent Light Source (LCLS) free electron laser (FEL) at the SLAC National Accelerator Laboratory. We analyzed the O 1s X-ray emission spectra recorded from atomic oxygen adsorbed on a Ru(0001) surface at a synchrotron beamline (SSRL, BL13-2) and an FEL beamline (LCLS, SXR). We have demonstrated conditions that provide negligible amount of FEL induced damage of the sample. In addition we show that the setup is capable of tracking the temporal evolution of electronic structure during a surface reaction of submonolayer quantities of CO molecules desorbing from the surface.

  • 2013. M. Dell'Angela (et al.). Science 339 (6125), 1302-1305

    We used the Linac Coherent Light Source free-electron x-ray laser to probe the electronic structure of CO molecules as their chemisorption state on Ru(0001) changes upon exciting the substrate by using a femtosecond optical laser pulse. We observed electronic structure changes that are consistent with a weakening of the CO interaction with the substrate but without notable desorption. A large fraction of the molecules (30%) was trapped in a transient precursor state that would precede desorption. We calculated the free energy of the molecule as a function of the desorption reaction coordinate using density functional theory, including van der Waals interactions. Two distinct adsorption wells-chemisorbed and precursor state separated by an entropy barrier-explain the anomalously high prefactors often observed in desorption of molecules from metals.

  • 2015. Henrik Östrom (et al.). Science 347 (6225), 978-982

    Femtosecond x-ray laser pulses are used to probe the carbon monoxide (CO) oxidation reaction on ruthenium (Ru) initiated by an optical laser pulse. On a time scale of a few hundred femtoseconds, the optical laser pulse excites motions of CO and oxygen (O) on the surface, allowing the reactants to collide, and, with a transient close to a picosecond (ps), new electronic states appear in the OK-edge x-ray absorption spectrum. Density functional theory calculations indicate that these result from changes in the adsorption site and bond formation between CO and O with a distribution of OC-O bond lengths close to the transition state (TS). After 1 ps, 10% of the CO populate the TS region, which is consistent with predictions based on a quantum oscillator model.

Visa alla publikationer av Jörgen Gladh vid Stockholms universitet

Senast uppdaterad: 13 september 2018

Bokmärk och dela Tipsa