Profiles

Rydh

Andreas Rydh

Universitetslektor, docent

View page in English
Arbetar vid Fysikum
Telefon 08-553 786 92
E-post andreas.rydh@fysik.su.se
Besöksadress Roslagstullsbacken 21
Rum A2:1057
Postadress Fysikum 106 91 Stockholm

Om mig

Min forskning är inriktad mot termodynamisk, transport och strukturell karakterisering av material med nya elektroniska egenskaper vid låga temperaturer. Särskilt fokus ligger på superledande, magnetiska och andra system med elektroniska fasövergångar, där effekterna av ett magnetfält och fältriktning är centrala. Den huvudsakliga experimentella tekniken är nanokalorimetri, ibland kombinerad med samtidig röntgendiffraktion.

Publikationer

I urval från Stockholms universitets publikationsdatabas
  • 2017. K. Willa (et al.). Review of Scientific Instruments 88 (12)

    Recent advances in electronics and nanofabrication have enabled membrane-based nanocalorimetry for measurements of the specific heat of microgram-sized samples. We have integrated a nanocalorimeter platform into a 4.5 T split-pair vertical-field magnet to allow for the simultaneous measurement of the specific heat and x-ray scattering in magnetic fields and at temperatures as low as 4 K. This multi-modal approach empowers researchers to directly correlate scattering experiments with insights from thermodynamic properties including structural, electronic, orbital, and magnetic phase transitions. The use of a nanocalorimeter sample platform enables numerous technical advantages: precise measurement and control of the sample temperature, quantification of beam heating effects, fast and precise positioning of the sample in the x-ray beam, and fast acquisition of x-ray scans over a wide temperature range without the need for time-consuming re-centering and re-alignment. Furthermore, on an YBa2Cu3O7-delta crystal and a copper foil, we demonstrate a novel approach to x-ray absorption spectroscopy by monitoring the change in sample temperature as a function of incident photon energy. Finally, we illustrate the new insights that can be gained from in situ structural and thermodynamic measurements by investigating the superheated state occurring at the first-order magneto-elastic phase transition of Fe2P, a material that is of interest for magnetocaloric applications.

  • 2015. I. Lukyanchuk (et al.). Nature Physics 11 (1), 21-25

    Depending on the Ginzburg-Landau parameter kappa, superconductors can either be fully diamagnetic if kappa < 1/root 2 (type I superconductors) or allow magnetic flux to penetrate through Abrikosov vortices if kappa > 1/root 2 (type II superconductors; refs 1,2). At the Bogomolny critical point, kappa = kappa(c) = 1/root 2, a state that is infinitely degenerate with respect to vortex spatial configurations arises(3,4). Despite in-depth investigations of conventional type I and type II superconductors, a thorough understanding of the magnetic behaviour in the near-Bogomolny critical regime at kappa similar to kappa(c) remains lacking. Here we report that in confined systems the critical regime expands over a finite interval of kappa forming a critical superconducting state. We show that in this state, in a sample with dimensions comparable to the vortex core size, vortices merge into a multi-quanta droplet, which undergoes Rayleigh instability(5) on increasing kappa and decays by emitting single vortices. Superconducting vortices realize Nielsen-Olesen singular solutions of the Abelian Higgs model, which is pervasive in phenomena ranging from quantum electrodynamics to cosmology(6-9). Our study of the transient dynamics of Abrikosov-Nielsen-Olesen vortices in systems with boundaries promises access to non-trivial effects in quantum field theory by means of bench-top laboratory experiments.

  • 2015. Donato Campanini (et al.). Physical Review B. Condensed Matter and Materials Physics 91 (24)

    We report on specific heat measurements on clean overdoped BaFe2(As1-xPx)(2) single crystals performed with a high resolution membrane-based nanocalorimeter. A nonzero residual electronic specific heat coefficient at zero temperature gamma(r) = C/T backslash(T -> 0) is seen for all doping compositions, indicating a considerable fraction of the Fermi surface ungapped or having very deep minima. The remaining superconducting electronic specific heat is analyzed through a two-band s-wave alpha model in order to investigate the gap structure. Close to optimal doping we detect a single zero-temperature gap of Delta(0) similar to 5.3 meV, corresponding to Delta(0)/k(B)T(c) similar to 2.2. Increasing the phosphorus concentration x, the main gap reduces till a value of Delta(0) similar to 1.9 meV for x = 0.55 and a second weaker gap becomes evident. From the magnetic field effect on gamma(r), all samples however show similar behavior [gamma(r)(H) -gamma(r)(H = 0) proportional to H-n, with n between 0.6 and 0.7]. This indicates that, despite a considerable redistribution of the gap weights, the total degree of gap anisotropy does not change drastically with doping.

  • 2016. Zhu Diao (et al.). Physical Review B. Condensed Matter and Materials Physics 93 (1)

    We investigate the electronic specific heat of superoptimally substituted BaFe2(As1-x P-x(x))(2) single crystals in the superconducting state using high-resolution nanocalorimetry. From the measurements, we extract the substitution dependence of the condensation energy, superconducting gap Delta, and related microscopic parameters. We find that the anomalous scaling of the specific heat jump Delta C proportional to T-c(3) , found in many iron-based superconductors, in this system originates from a T-c-dependent ratio Delta/k(B)T(c) in combination with a substitution-dependent density of states N(epsilon(F)). A clear enhancement is seen in the effective mass m* as the composition approaches the value that has been associated with a quantum critical point at optimum substitution. However, a simultaneous increase in the superconducting carrier concentration n(s) yields a penetration depth lambda that decreases with increasing T-c without sharp divergence at the quantum critical point. Uemura scaling indicates that T-c is governed by the Fermi temperature T-F for this multiband system.

  • 2014. M. Hudl (et al.). Physical Review B. Condensed Matter and Materials Physics 90 (14), 144432

    The specific heat and thermodynamics of Fe2P single crystals around the first-order paramagnetic to ferromagnetic (FM) phase transition at T-C similar or equal to 217 K are empirically investigated. The magnitude and direction of the magnetic field relative to the crystal axes govern the derived H-T phase diagram. Strikingly different phase contours are obtained for fields applied parallel and perpendicular to the c axis of the crystal. In parallel fields, the FM state is stabilized, while in perpendicular fields the phase transition is split into two sections, with an intermediate FM phase where there is no spontaneous magnetization along the c axis. The zero-field transition displays a textbook example of a first-order transition with different phase stability limits on heating and cooling. The results have special significance since Fe2P is the parent material to a family of compounds with outstanding magnetocaloric properties.

  • 2012. Stella Tagliati, Vladimir M. Krasnov, Andreas Rydh. Review of Scientific Instruments 83 (5), 055107

    A differential, membrane-based nanocalorimeter for general specific heat studies of very small samples, ranging from 0.5 mg to sub-mu g in mass, is described. The calorimeter operates over the temperature range from above room temperature down to 0.5 K. It consists of a pair of cells, each of which is a stack of heaters and thermometer in the center of a silicon nitride membrane, in total giving a background heat capacity less than 100 nJ/K at 300 K, decreasing to 10 pJ/K at 1 K. The device has several distinctive features: (i) The resistive thermometer, made of a Ge1-xAux alloy, displays a high dimensionless sensitivity |dlnR/dlnT| greater than or similar to 1 over the entire temperature range. (ii) The sample is placed in direct contact with the thermometer, which is allowed to self-heat. The thermometer can thus be operated at high dc current to increase the resolution. (iii) Data are acquired with a set of eight synchronized lock-in amplifiers measuring dc, 1st and 2nd harmonic signals of heaters and thermometer. This gives high resolution and allows continuous output adjustments without additional noise. (iv) Absolute accuracy is achieved via a variable-frequency-fixed-phase technique in which the measurement frequency is automatically adjusted during the measurements to account for the temperature variation of the sample heat capacity and the device thermal conductance. The performance of the calorimeter is illustrated by studying the heat capacity of a small Au sample and the specific heat of a 2.6 mu g piece of superconducting Pb in various magnetic fields.

  • 2011. Stella Tagliati, Andreas Rydh. Thermochimica Acta 522 (1-2), 66-71

    To achieve accurate results in nanocalorimetry a detailed analysis and understanding of the behavior of the calorimetric system is required. There are especially two system-related aspects that should be taken in consideration: the properties of the empty cell and the effect of the thermal link between sample and cell. Here we study these two aspects for a membrane-based system where heater and thermometer are both in good contact with each other and the center of the membrane. Practical, analytical expressions for describing the frequency dependence of heat capacity, thermal conductance, and temperature oscillation of the system are formulated and compared with measurements and numerical simulations. We finally discuss the experimental conditions for an optimal working frequency, where high resolution and good absolute accuracy are combined.

Visa alla publikationer av Andreas Rydh vid Stockholms universitet

Senast uppdaterad: 13 april 2018

Bokmärk och dela Tipsa